Hi all,
we just got a sandbox system (IBP 4.0.2) with the sample planning area SAP2. Since I couldn't see any data in the analytics part, I wanted to assign the visibility filter VIEWALL, but it did not show up. Therefore, I tried to activate SAP2 (even though it was shown as active). This activation ended in an error, saying:
E - Calculation ID HGROSSCOST@PERPRODLOCCUST contains three or more different key figures. We recommend dividing the calculation into separate calculations to avoid this situation in future.
However, when I check the definition of HGROSSCOST@PERPRODLOCCUST, the calculation contains only two different input key figures:
CONSTRAINEDDEMAND@PERPRODLOCCUST * COSTPERUNIT@PERPRODLOC
and there is no additional input not used in the calculation.
I remember that we had a similar issue in a customer system when upgrading to 4.0.1 (?) and it was solved by adding this very same helper key figure HGROSSCOST to reduce the number of inputs for another key figure.
This time I can't find the error that is reported. I assume that I am not the only one with this issue as SAP2 is a template planning area that is delivered with each test and sandbox system and it has not been changed from our side.
Any idea is appreciated.
Thanks,
Jonathan