Hello,
Have added a Z condition type. Issue is that the 'Qty. Conversion' field does not appear in 'Condition values' while going to 'Item-condition-details' within PO. This is leading to incorrect calculations; as system is not considering the correct values.
Ex 100 CM and 1M though equal; its considering the numerical value alone instead of the conversion.
Any thoughts on how to have the 'Qty. conversion' in the item condition details area. See ss.
Also; existing config set up is also added.
Went through the post http://scn.sap.com/thread/899053; but did not work in my case.
Regards